Web moped2.org
 Previous Message Message Index Next Message 
Re: Need help starting my Puch  lifei-@webtv.net
 Apr 03, 2002 20:05 PST 
Well I think your next step is to check the points and coil.IF it was
running before shipping maybe a wire on the coil broke loose otherwise
it sounds like you have a fried coil.lis
From: Justin Lehrer <just-@yahoo.com>
Subject: Re: Need help starting my Puch
Apr 2002 17:54:27 PST
--0-1371340492-1017885267=:65474
OK, I just worked on it with a friend who knows 2 strokes well. He confirmed that there is no spark. He also checked to make sure the kill switch wasn't ground out, and that the points were clean. What's left? If you have no spark, what could cause that!?
Also, I would like to hear your opinions on the issue of whether the seller of this moped was dishonest. I purchased on ebay. Here is the link so you can see the description: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=1812767679
The guy has been seemingly helpful, available over the phone, assured me that he had it running every day last week, it starts right up. But no spark....seems like that is unlikely to occur during shipment doesn't it? What do you think? Do I have grounds to think the seller lied about the condition?
Thanks for your advice!
Justin
Harry <sydcat-@cs.com> wrote: You might need help in holding the plug to the head while you pedal. Make
sure you have a good ground. No painted surface.
I do not know enough about a Puch to advise if no spark. You will have to get
into the magneto to check the points.. Harry
 Previous Message Message Index Next Message 



Forums at Moped2.org Privacy policy
Moped2.org Home My other sites

Home   Contact
Wikipedia Affiliate Button