Web moped2.org
 Previous Message Message Index Next Message 
Re: How to tighten a chain  MacDo-@aol.com
 May 17, 2002 05:01 PDT 
Dave, the process to tighten the chain is moving the rear wheel back. To do
this, you will need to loosen the axle nuts on each side of the rear wheel.
This will require a metric wrench, 16 mm I think but I'm not sure. Then
adjust the tensioners, 10 mm wrench needed, on each side an even amount so
the wheel stays straight but moves back until a small amount of slack remains
in the chain. Retighten the axle nuts and your done.
Joe
 Previous Message Message Index Next Message 



Forums at Moped2.org Privacy policy
Moped2.org Home My other sites

Home   Contact
Wikipedia Affiliate Button