Web moped2.org




Date: Sun, 30 Apr 2000 05:01:59
Subject: Re: 1991 tomos bullet tt
From: Robbert
Reply to author   Post followup (list members only)   Back to index   Subscribe to the mailing list   Unsubscribe from the list  

Mike _____ wrote:
> > I just recently purchased a 91 Tomos bullet tt(a3 engine) a couple days ago.
> I test rode it down a hill and it was great. going back up the hill it was
> lugging a little but it made it. the next day i started it right up to go
> for a ride and it took about 10 min to what i thought was warming up time.
> it rode it down a hill on my road and no problems it shifted well. going
> back up the hill though was a different story. It didn't make it. So i began
> to investigate. I looked in the carb, cleaned it. replaced an old spark plug
> with a brand new one. tried again. same problem. but this time i noticed
> something. there was a liquid on the outside of the cylinder wall. so i
> figure it had to be compression. took off cylinder head, looked inside, no
> head gasket. so i asked around and found out there aren't head gaskets. so i
> cleaned out all the ports but there really wasn't much to clean. ANY
> IDEAS?!?!?!?!?!?! i am totally stumped. please, help me!?!?!

If the problem is a leak, you can put in a gasket anyway. Or you have to
make sure the head closes off well. You can sand both head and cylinder
top with real fine sandpaper, better would be sanding paste, to make em
absolutely flat.

Robbert
Newsletters, Tips and Discussions on Your Favorite Topics

Reply to author   Post followup (list members only)   Back to index   Subscribe to the mailing list   Unsubscribe from the list  



Forums at Moped2.org Privacy policy
Moped2.org Home My other sites

Home   Contact
Wikipedia Affiliate Button