| Date: | Thu, 13 Jul 2000 13:54:06 |
| Subject: | Re: gas ports |
| From: | Peter Staal |
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
hi
blud object, old screwdriver like that.
don't make scraches in the metal, or hit the cylinder walls during your
'job' , could protect it bij putting in a piece of cardboard.
finish it off by polishing the walls with fine sand paper.
wash (very) clean with petroleum before use.
make sure the intake connects smooth (internaly !) , no pieces of gasket in
the flow..
same goes for the exhaust.
..dirty inlet...what happend ?
peter
----- Oorspronkelijk bericht -----
Van: Mike _____
Aan:
Verzonden: donderdag 13 juli 2000 17:30
Onderwerp: gas ports
> anyone know the correct way to clean intake ports and exhaust port on a
> cylinder of a 50 cc moped???
> > Mike
> > 1991 Tomos Bullet TT
> 1976 Motobecane 40V
> list.
>
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
