Hi mopeders, Stupid... should've the thought of that solution, after all they do use contactless systems for ignition strobes... of course it would be possible this way, then you only have to find a device that can be attached to the handle bars neatly. Greets Jeroen van Ingen -----Original Message----- From: Peter Staal To: moped@topica.com Date: dinsdag 4 april 2000 7:55 Subject: Re: tachometer on a c90 Hi go to a car shop, they have em'; for all 4 strokers, one extra wire from the coil and it is done, some have even contactless sensors, on one sppl cable. had one on a tuned tomos, but is burns out every time, the voltage gets dangerously high, and had no extra voltage regulator in line with the device.:( Peter. > Hi there, > > I guess it's almost impossible to put a tacho on a C90. I have an old C90 > from around '67 or '68, and it doesn't have a connector for a tacho. If you > really, really want one, you could try to find an engineer in your > surroundings who can design one for you. With a few adaptations it would be > possible to put an electronic counting system on the camshaft, but then you > would have to use a digital tacho and some electronics to do some math on > your signal. The main problem is: as far as I know, there are no complete > tacho sets that are suitable for a C90. > > -----Original Message----- > From: C90nutter2001@cs.com > To: moped@topica.com > Date: maandag 3 april 2000 7:55 > Subject: tachometer on a c90 > > does ne1 know how i can connect a tachometer to a c90 > thanx > list. list.
|