| Date: | Thu, 04 May 2000 15:05:03 |
| Subject: | Re: Pacer (was: Re: Yamaha Job vs. Puch Magnum) |
| From: | Peter Staal |
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
hi,
understood :)
, 10mm is extreme small yes, can't you cut a piece off, at a wider diameter
? and weld it on again?, the shorter the pipe the better tuned for high
rev's...
peter.
----- Oorspronkelijk bericht -----
Van: K. Brant Niggemyer
Aan:
Verzonden: woensdag 3 mei 2000 22:38
Onderwerp: Re: Pacer (was: Re: Yamaha Job vs. Puch Magnum)
> > Hi
> > What do you mean by the header?
> > I mean the point where the exaust system first bolts on to the manifold.
> > > It is normal to have a 10 -15 mm outlet at
> > the end of the pipe.. while at the beginning / manifold / cylinder port
it
> > is 20-28mm diam.. is usual.
> > Exactly. The exhaust manifold has a diamater of about 25 mm. But the
pipe that
> bolts on is about 10mm -- where it meets the manifold. So you see what I
mean
> when I say the header is small.
> list.
> Newsletters, Tips and Discussions on Your Favorite Topics
>
Newsletters, Tips and Discussions on Your Favorite Topics
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
