check your compression between the cylinder head and cylinder. if it has little power it could be losing comp. does this model have a head gasket??? if so, make sure it isn't blown. if not, clean both surfaces (head to cylinder) well and sand with a very fine sand paper. tighten head bolts all the same. >From: Peter Staal >Reply-To: moped@topica.com >To: moped@topica.com >Subject: Re: Tomos Troubles >Date: Mon, 29 May 2000 15:33:46 -0700 > >hi don, > >why did he replace the reed valve....and isn't that happening again ? > >If your plug still sparks with lights on, passed top-test.. > >If you still see smoke coming outoff the exhaust, and it gives pressure / >force to your hand when in the exhaustgas flow- 1 or 2" away from the pipe >end, exhaust passed test. > >cilinder ./ piston fit alright? piston rings could be worn out..or worser >the crankcasebearings.or.seals. or on the bright side, a leaking >head-gasket >(does the cilinder sweat >oily smudge? ) > >0.35 - 0.45 mm point gap, but if it runs it stays the same, so no reasing >for dieing out. On the otherhand the coil could overhead if bad.. is the >magneto still in a fixed position?, if loose it gives a irrational motor >behaviour :). > >does it die out of fuel shortage , or no / bad spark? >you can smell the difference , at least at the exhaust. >it comes to me as fuel shortage, when running full trottle it drives a to >lean mix and overheats. but starts right out when cooler... gives (cold) >bad starting behaviour, weak performance it all fits.. >and there is the reed valve in the picture again, you checked gas supply >upto there.. > >peter > >----- Oorspronkelijk bericht ----- >Van: >Aan: >Verzonden: maandag 29 mei 2000 21:04 >Onderwerp: Tomos Troubles > > > Hello All, > > I inhierted a '93 Tomos A35 from a friend (mechanic) who could never get >it > > running correctly. (Sounds bad already, doesn't it? ) I've fooled with >it > > now for a few months off and on and am pretty fed up. I've cleaned and > > adjusted the points, checked the plug and spark (OK), rebuilt the carb, > > checked the piston, etc. The previous owner replaced the reed valve. >Darn > > thing has very little power and dies after running it as fast as it will >go > > for a few minutes...but then starts immediately. I checked the fuel >feed >and > > it looks good. 1) anyone have the correct point setting? 2) any >electrical > > test that might reveal a fault, 3) any Tomos prayers that work? > > Thanks for all help, > > Don Lewis > > Santa Barbara, CA > > '80 Moto Marina > > '93 Tomos A35 > > '96 Honda CBR600F3 >list. > > > >list. >Newsletters, Tips and Discussions on Your Favorite Topics > Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com Newsletters, Tips and Discussions on Your Favorite Topics
|